Rotary sushi equipment maintenance and maintenance skills

In the past few years, rotating hot pot and rotating hot pot have become more popular in the catering industry. In a highly competitive market, it is necessary to choose high-quality rotating hot pot equipment to open a rotating hot pot restaurant. With the dramatic improvement of people's living standards, green services and food safety have become everyone's pursuit. In this way, the maintenance and maintenance of rotating hot pot equipment will become more and more important, and a clean and hygienic restaurant environment will become more and more popular.

In order to facilitate daily hygiene and cleaning, in addition to the movable inspection door in the corner of the rotating hot pot equipment, the straight wall skirt decoration board should be reserved for the sanitary cleaning door, and the spacing should not exceed 3 meters.

When shut down, the chain and equipment track must be wiped with a towel every morning and evening. You can lift the crescent-shaped chain slightly in the straight part and wipe it with a wet towel. The chain can not rise to the corner of the arc, brush clean with a small brush.

In order to ensure the service time of the gearbox and motor and reduce mechanical failure, worm gear oil must be added. In most cases, it is checked once a year and found that the amount of lubricating oil is small and it is necessary to add lubricating oil.

Rotary sushi equipment

The rotary Hot Pot Conveyor Belt is a chain transmission equipment that needs to be lubricated once a month to the conveyor belt.

Due to the continuous wear of the rotary hot pot conveyor belt in long-term use, the sprocket gear is easy to wear, resulting in unstable bite of the sprocket and the rotary hot pot conveyor belt, and even chain suspension. Based on the usage of a large number of customers, the following summary is made, and then some technical improvements are made to the sprocket.

The rotary hot pot conveyor belt adopts a wear-resistant Plate combination sprocket, which is composed of a wheel hub and a wear-resistant protection plate. After special heat treatment, the wear protection sheet has moderate hardness, high strength and good wear resistance. The gear teeth of the half-tooth structure only engage with every two circles and chain of the main shaft, so the service time of the gear teeth is twice that of the teeth of the non-half-tooth structure.

Even if it is worn, it only needs to replace the protection plate, which can be easily replaced without removing the bearing parts. The rotary hot pot conveyor belt can still be used for a long time, saving time and materials, reducing maintenance costs, and better extending the use time of the rotary hot pot equipment components.